I know KDE has a calendar, not sure how well it’d work for your use case but it’s there!

Oh cool!

Of3+ perhaps?

(Correction: forgot the +)

I believe (from prior knowledge and a little bit of research), é/è/ê are all french, ë is dutch, sometimes french and occasionally in english, ï is i think similar and ÿ is also french (and possibly turkish? Not sure). No pressure to add them, it just might be nice if you have the time! :)

Sounds like quite a nice weekend. Best of luck & get well soon to your doggo!

TV’s backlight died a couple of days ago and I’m waiting for the replacements to arrive (hopefully tomorrow), might be a bugger to fix but it’s worth a shot anyway (only a £20 part and if I can’t fix it it’s going in the bin and being replaced anyway).

Otherwise, family from abroad are staying nearby this week so we’ll be taking them around the area!

Fair enough, if that’s the scope of your knowledge anyway then it makes sense. Could just be something to add in a later version (unicode wasn’t built in a day after all)!

Also in addition to my other comment, it would be nice to add the circumflex, forward/backward accents (even if they’re possible just show them before/after the main alphabet in the preview).

Also, ë, ï and why not ÿ to complete the set? :)

As nottheengineer pointed out, the umlauts being conjoined just doesn’t feel right - your reasoning behind it makes total sense, it’s just a little bit too wrong for my eyes.

I would instead personally prefer them misaligned/asymmetrical (ouch, i know) as that would make what they are clear (i would probably take a minute to adjust to that and imo that’s not something that should be necessary for a typeface.

That nitpick aside, it does feel very well-rounded to look at, you did well!

In my opinion it depends on which letter you’re using. If it has a very striking doubled part such as N then I think it’d work!

I mean you know better than me (I’m not even on twitter so everything i see is just the internet perspective of it). I’ll take your word for it as you’re probably right!

I wasn’t really involved with social media back then sadly, but yes I did get that general impression. Before all the toxicity really overtook it around 2020 it did seem quite pleasant.

Shame really, corporate greed taking something quite nice and milking it so hard it’s absolutely ruined. Then again, it gives way to things like bluesky so i guess it has its upsides!

Having never been on twitter myself I’m especially entertained, watching and laughing from a far corner of the internet

Just FYI, you can duplicate an entire google docs/sheets/slides document by going File > Make a Copy, and in your case preserve comments by checking the relevant box!

Fair enough, i guess being that cheap it’s like many things - a roulette wheel of quality. Probably one of those things where I haven’t used anything else so don’t know what’s good and what isn’t!

Glad i recommended taking my judgement with a pinch of salt.

I’m not massively experienced with 3D printing so take this with a grain of salt.

That said though, I would personally consider what you would be doing in the future: If you’re just going to use it occasionally for small projects then it probably isn’t worth spending more than about 300€, but if you’re likely to use it a lot and eventually start to print more complex / intricate things and/or more often then getting a slightly nicer one would end up being worth it in my opinion!

Personally I have an Anet A8 (about 200€), it’s very basic and needs a lot of manual fiddling. Fortunately though, with a bit of tweaking in a slicer, it can produce quite nice prints in a reasonable time which is just fine for me as I only print infrequently and mostly things that don’t need to be too precise. There might be something better for that price point but if you’re just looking for something cheap that gets the job done then it’d probably serve you well!